Adjustment axial люфта a secondary shaft carry out in the following order:

Fig. 8.42. An arrangement of a template and a fixing arm for check axial люфта a secondary shaft

use special a template with a range of measurements of 3 mm and arms (see fig. 8.42 );

insert into the case of the bearing of a secondary shaft laying in thickness of 0,65 mm and establish a cup of the conic bearing. Thus the cup should be densely pressed to laying;

having established a secondary shaft, acquire and tighten nuts of a bearing arm of the bearing the moment of 30 N · m;

fix a template (see fig. 8.42 ) and establish micrometer indications on a zero with a preliminary tightness;

moving a secondary shaft, take readings of a micrometer (the template during operation should not move);

combine: а) the measured value,) constant value = 0,20 mm, in) value of thickness of laying = 0,65 mm. Proceeding from requirements pick up laying of necessary thickness;

having dismantled a secondary shaft, establish on it the picked-up laying;

establish an external ring of the bearing;

grease a shaft with transmission oil and, having established it into place, tighten lock nuts the moment of 30 N · m;

check axial люфт.