Removal make in the following order:

– turn on the hatch and put it in inclined situation;

– establish the adaptation, opiry it on edge of the decorative panel of a frame of the hatch;

– submit an elevating framework down, to those юр while the first line of a frame of a horizontal framework will not come into an adaptation groove;

Fig. 15.71. Removal of a cover of the hatch assembled with an elevating framework by means of the adaptation 3195: 1–hatch; 2–adaptation

– strike blow to the adaptation with a palm, in the direction specified by an arrow B (fig. 15.71) and beat out a hatch cover assembled with an elevating framework;

– displace a cover back until the adaptation will not rest against the body roof edge then clean the adaptation;

Fig. 15.72. Push a frame of an aperture of the hatch back against the stop into the limiter (it is specified by an arrow)

– push a frame of an aperture of the hatch back against the stop into the limiter (fig. 15.72) ;

– unscrew screws of fastening of a cover of the hatch (screws internal 6-faced shlitsa have) and remove the panel from above.