VW Passat repair


+ 1. Ekspluatatsiiya of the car
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Power supply system
+ 6. Ignition system
+ 7. Coupling
+ 8. Transmission
+ 9. Drive of forward wheels
+ 10. Suspension brackets
+ 11. Steering
+ 12. Brake system
+ 13. Wheels and tires
+ 14. Systems of heating, ventilation and conditioning
- 15. Electric equipment
   + 15.1. Technical characteristics
   15.2. Security measures at work with electric equipment
   + 15.3. Detection of not closed chain
   + 15.4. Storage battery
   + 15.5. Generator
   + 15.6. Starter
   15.7. Block of safety locks and relay
   15.8. Replacement of the lock of ignition
   + 15.9. Switches
   + 15.10. Combination of devices
   + 15.11. Internal lighting and lighter
   + 15.12. Headlights
   - 15.13. Windscreen cleaner
      15.13.1. Adjustment of a cleaner of a windscreen
   15.14. Windscreen washers
   15.15. Cleaner of back glass
   + 15.16. Central lock
   + 15.17. Hatch
+ 16. Body
+ 17. Electric circuits


Repair B3-B4/Passat B3-B4 Volkswagen Passat>> Electric equipment>> Windscreen cleaner




Fig. 15.52. Screen wiper mechanism. At installation of a crank or at adjustment of levers of brushes the electric motor should be in a starting position: 1, 17 – a nut; 2–plastic washer; 3–lock ring; 4–laying; 5–cleaner arm; 6–spring washer; 7–cleaner shaft; 8–bolt; 9–rubber washer; 10-crank; 11, 13 – draft of turning on of the relay; 12-cleaner electric motor; 14-rubber brush; 15-holder of a brush; 16-spring bracket; 18-washer; 19-brush lever


On fig. 15.52 elements of the mechanism of a cleaner of a windscreen are shown. At installation of a crank or at adjustment of levers of brushes the electric motor should be in situation in which there is an engine shaft after switching off of a cleaner and operation of the automatic device.

Fig. 15.53. The crank puts on on a shaft in a starting position of the electric motor. At installation to sustain the size а=5 mm


Fig. 15.54. The correct position of levers of brushes at assembly


On fig. 15.53 the corner of installation of a crank on an electric motor shaft is shown. On fig. 15.54 the correct position of levers of the brushes established on shlitsevy shaft is shown. The specified distances are measured from edge of an overlay of a windscreen. The size A (from the passenger) should be about 50 mm. The size B (from the driver) should be about 35 mm.