VW Passat repair


+ 1. Ekspluatatsiiya of the car
+ 2. Maintenance
- 3. Engines
   - 3.1. Petrol engines of configuration of R4
      3.1.1. Technical characteristics
      3.1.2. General information
      3.1.3. Compression definition in cylinders
      3.1.4. Gear belt of a drive of the gas-distributing mechanism
      3.1.5. Camshaft and pushers
      3.1.6. Removal and installation of a head of the block of cylinders
      3.1.7. Repair of a head of the block of cylinders
      3.1.8. Flywheel
      3.1.9. Intermediate shaft
      3.1.10. Oil pallet
      3.1.11. Replacement of epiploons of a cranked shaft
      3.1.12. Oil pump
      3.1.13. Pistons and rods
      3.1.14. Removal and engine installation
      3.1.15. Engine dismantling
      3.1.16. Fault detection of the block of cylinders and cranked shaft
      3.1.17. Engine assembly
      3.1.18. Engine start-up after major maintenance
   + 3.2. Petrol engine of configuration of VR6
   + 3.3. Diesel engines
+ 4. Cooling system
+ 5. Power supply system
+ 6. Ignition system
+ 7. Coupling
+ 8. Transmission
+ 9. Drive of forward wheels
+ 10. Suspension brackets
+ 11. Steering
+ 12. Brake system
+ 13. Wheels and tires
+ 14. Systems of heating, ventilation and conditioning
+ 15. Electric equipment
+ 16. Body
+ 17. Electric circuits


Repair B3-B4/Passat B3-B4 Volkswagen Passat>> Engines>> Petrol engines of configuration of R4>> Engine start-up after major maintenance
After engine installation in the car check levels of engine oil and cooling liquid.
Remove spark plugs.
Remove the relay of a food or a safety lock of the fuel pump for its de-energization.
Rotate a cranked shaft a starter before switching off of a lamp of emergency pressure of oil. If the lamp does not die away within several seconds after the beginning of rotation of a cranked shaft, switch off a starter and check level of engine oil and serviceability of the oil filter. Further check an integrity of a wire of the sensor of emergency pressure of oil.
Establish spark plugs.
Establish the relay of a food or a safety lock of the fuel pump.
Start up the engine and check tightness of all systems. Dymleniye of the engine at start-up — the normal phenomenon as burns out the oil which has got on a detail at assembly of the engine.
Check once again levels of engine oil and cooling liquid after several minutes of operation of the engine.
If in the course of repair on the engine new pistons, piston rings or loose leaves of a cranked shaft were established, it is necessary to execute its running in before run of 1000 km. At a running in do not maintain the engine with the maximum loading. After end of a running in it is recommended to replace engine oil and the oil filter.








429b39f6