VW Passat repair


+ 1. Ekspluatatsiiya of the car
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Power supply system
+ 6. Ignition system
+ 7. Coupling
+ 8. Transmission
+ 9. Drive of forward wheels
+ 10. Suspension brackets
+ 11. Steering
+ 12. Brake system
+ 13. Wheels and tires
+ 14. Systems of heating, ventilation and conditioning
+ 15. Electric equipment
- 16. Body
   + 16.1. General information
   16.2. Care of a body
   - 16.3. Insignificant damages of a body
      16.3.1. Processing of scratches
      16.3.2. Repair of dents in a body design
      16.3.3. Repair of the rusted openings or holes in a body design
      16.3.4. Shpatlevka and body painting
   16.4. Considerable damages of a body
   16.5. Moldings, facing of wheel niches
   + 16.6. Cowl elements
   16.7. Forward and back bumpers
   16.8. Forward cross-section beam of a body
   16.9. Forward wing
   + 16.10. Luggage carrier elements
   + 16.11. Elements of a back door (cars with a body the versatile person)
   16.12. Hinges and locks
   16.13. Elimination of jingle of doors
   + 16.14. Elements of a forward door
   + 16.15. Elements of a back door
   16.16. Internal rear-view mirror
   16.17. Central console
   + 16.18. Combination of devices
   16.19. The receiver with coding system
   16.20. Perchatochny box
   16.21. Dashboard
   + 16.22. Forward seats
   + 16.23. Back sitting
   + 16.24. Seat belts
+ 17. Electric circuits


429b39f6





Repair B3-B4/Passat B3-B4 Volkswagen Passat>> Body>> Insignificant damages of a body>> Repair of dents in a body design
At deep dents of elements of a design of a body first of all try to curve a dent back before the maximum approach to a normal form of a body. Body metal in a place of blow is extended, therefore the complete recovery of an initial form is impossible. Optimum it is considered dent alignment approximately on 3 mm below level of a surrounding surface. If there is an access to dent inside, follows accurately выстучать its hammer with a wooden or plastic head. During this operation it is necessary to press densely to outer side of a tapped surface wooden whetstone corresponding to it. It is required for amortization of blows of a hammer and for prevention of a flexure of more extensive area. If the dent is in that area of a body where access from a reverse side is complicated or impossible, in the deepest points of a dent it is possible to drill some small openings, in which to screw up self-cutting screws then to extend a dent by means of flat-nose pliers for acting heads of screws.
Remove paint from the damaged area and at distance of 20 mm round it.
Easier all this can be made, using a wire brush or an emery paper got on a circle, fixed in an electrodrill. After alignment of a dent put on it a layer of a shpatlevka, paint and a polyrole.