VW Passat repair


+ 1. Ekspluatatsiiya of the car
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Power supply system
+ 6. Ignition system
+ 7. Coupling
+ 8. Transmission
+ 9. Drive of forward wheels
+ 10. Suspension brackets
+ 11. Steering
+ 12. Brake system
+ 13. Wheels and tires
+ 14. Systems of heating, ventilation and conditioning
+ 15. Electric equipment
- 16. Body
   + 16.1. General information
   16.2. Care of a body
   + 16.3. Insignificant damages of a body
   16.4. Considerable damages of a body
   16.5. Moldings, facing of wheel niches
   + 16.6. Cowl elements
   16.7. Forward and back bumpers
   16.8. Forward cross-section beam of a body
   16.9. Forward wing
   + 16.10. Luggage carrier elements
   + 16.11. Elements of a back door (cars with a body the versatile person)
   16.12. Hinges and locks
   16.13. Elimination of jingle of doors
   + 16.14. Elements of a forward door
   + 16.15. Elements of a back door
   16.16. Internal rear-view mirror
   16.17. Central console
   + 16.18. Combination of devices
   16.19. The receiver with coding system
   16.20. Perchatochny box
   16.21. Dashboard
   + 16.22. Forward seats
   + 16.23. Back sitting
   + 16.24. Seat belts
+ 17. Electric circuits


429b39f6





Repair B3-B4/Passat B3-B4 Volkswagen Passat>> Body>> Forward wing
Removal make in the following order:
– will hang out the car and fix it on basic racks;

Fig. 16.9. Elements of fastening of the loose leaf of an arch of a wheel: 1–an extending percussion cap


– remove the loose leaf of an arch of a wheel which (fig. 16.9) fastens plastic percussion caps and screws ;
– for improvement of access to fastenings of the loose leaf of an arch of a wheel, remove a forward wheel;

Fig. 16.10. Access to bolts of fastening of a forward wing


– press down a bumper about a forward part of a wing and unscrew fastening bolts (fig. 16.10) ;
– at a bumper otzhatiya down it is possible to use rubber wedges;

       NOTE
Be careful: do not damage paint. In order to avoid damages, the places being in close proximity with bolts, paste over with a sticky tape.


Fig. 16.11. An arrangement of bolts of fastening of a forward wing in a back part of an arch of a wheel


– unscrew two bolts of fastening of back edge of an arch of a wheel (fig. 16.11) ;
– unscrew bolts of fastening of the upper edge of an arch and accurately remove a wing;
– for separation of a wing from a body soften protective mastic by means of the hair dryer.

       NOTE
For cars with an opening roof, do not jam a water waste hose.

Before wing installation into place clear an interfaced surface and put zinc paste (VW AKI 381 035 50) in places of fastening of a wing to a wheel niche and a forward rack.

Fig. 16.12. Arrangement of bolts of fastening of the upper edge of a forward wing


Combine openings under bolts and wrap bolts of fastening of a wing (fig. 16.12) .

Fig. 16.13. Gaps on perimeter of a forward wing: 1= from 4 to 6 mm, 2 = from 4 to 6 mm


At installation it is necessary to sustain a uniform demanded gap between a wing and a cowl (fig. 16.13) .