VW Passat repair


+ 1. Ekspluatatsiiya of the car
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Power supply system
+ 6. Ignition system
+ 7. Coupling
+ 8. Transmission
+ 9. Drive of forward wheels
+ 10. Suspension brackets
- 11. Steering
   11.1. General information
   11.2. Steering wheel
   - 11.3. Steering column
      11.3.1. Removal
      11.3.2. Assembly and installation
   11.4. Regulator of provision of height of a steering column
   + 11.5. Replacement of protective covers of steering transfer
   + 11.6. Steering transfer
   11.7. Adjustment of position of steering drafts
   11.8. Replacement of steering drafts
   11.9. Replacement of tips of steering drafts
   + 11.10. Adjustment люфта steering transfer
   11.11. Replacement of liquid of the hydraulic amplifier of a steering
   + 11.12. Pump of the hydraulic booster of a steering
   11.13. Adjustment of a tension of belts of drives of auxiliary units
+ 12. Brake system
+ 13. Wheels and tires
+ 14. Systems of heating, ventilation and conditioning
+ 15. Electric equipment
+ 16. Body
+ 17. Electric circuits


429b39f6





Repair B3-B4/Passat B3-B4 Volkswagen Passat>> Steering>> Steering column>> Assembly and installation
Assembly and installation of a steering column carry out to sequences, return to removal, considering the next moments.
At assembly of the top end of a steering shaft compress laying of a clip of a spring on a shaft so that the spring appeared is completely compressed.

Fig. 11.8. A label of check of installation of a steering shaft in a column


Be convinced that the steering shaft is normally exposed in relation to the case of a steering column, thus the small ledge on the helmsman to a shaft should be combined with an opening on the case of a steering column (fig. 11.8) . If necessary extend a steering shaft to the limiter.
For installation of a new steering wheel on the car of early release it is necessary to put on by means of a nut of fastening of a steering wheel a shlitsevy part of a steering column the transitional plug (the additional spare part). Thus it is necessary to screw a nut till the end of a carving.

Fig. 11.2. Installation of a steering wheel of new type on a steering shaft of early releases with application of a special adapter


Unscrew a nut, establish a washer in thickness of 3 mm (the additional spare part) and finally tighten the transitional plug a nut of a steering wheel (see fig. 11.2 ).
Put the ignition lock on a steering column.
Tighten bolts and nuts the demanded moment.

Fig. 11.9. Control amount of installation of a steering wheel, mm


At replacement of a steering wheel be convinced that the gap between a surface of a nave of a steering wheel and the switch on a steering column makes 2–4 mm (fig. 11.9) .
Check work of a steering and switches of a steering column.