Removal of an epiploon of a flange of a semi-axis carry out in the following order:

– will hang out a forward part of the car and fix it basic racks;

– unscrew bolts of fastening and disconnect a power shaft from a flange of a drive of a transmission. At replacement of the right sealing ring of differential unscrew a counterbalance from the bottom frame of a steering, and an internal part of a power shaft attach a wire to a body. At replacement of the left sealing ring of differential remove a power shaft from the car;

– on cars with a mechanical transmission remove a drive flange from a transmission. For removal of a flange of a semi-axis having arranged under a flange on a transmission case steel plates, roll in a flange long bolts until bolts, having rested against plates, will not take a flange from a transmission;

– on cars with an automatic transmission uncover in the central part of a flange, take a spring lock ring and a tarelchaty washer, previously having noted its situation. Take a semi-axis flange from an automatic transmission;

– using the corresponding tool or a screw-driver, take an epiploon from a transmission case. Note the provision of an epiploon.

PREVENTION The epiploon and lock spring ring are subject to obligatory replacement.

Installation of an epiploon of a flange of a semi-axis carry out in the following order:

– carefully clear a nest for installation of a sealing ring;

– oil working edges of an epiploon. establish an epiploon in a nest, it is correct it сориентировав. For installation of an epiploon use a tubular opravka of the corresponding diameter;

– on cars with an automatic transmission establish a spring in a persistent washer and establish them together with a konusny ring. Check, that the konusny ring settled down the party with a zaplechik to a persistent washer;

Fig. 9.23. Installation of a flange of a drive on an automatic transmission with use of the VW 3109 tool

– oil working edges of an epiploon and establish a semi-axis flange. Establish a semi-axis flange into place striking to it blows with a hammer through wooden whetstone. For installation of a flange of a semi-axis on cars with an automatic transmission use of the special VW3109 tool (fig. 9.23) is necessary ;

– on cars with an automatic transmission establish a tarelchaty washer, a lock ring and a protective cover;

– establish the internal hinge on a flange of a semi-axis of a transmission and tighten bolts the regulated moment;

– check oil level in a case of a transmission and if necessary add.