VW Passat repair


+ 1. Ekspluatatsiiya of the car
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Power supply system
+ 6. Ignition system
+ 7. Coupling
+ 8. Transmission
- 9. Drive of forward wheels
   9.1. General information
   9.2. Check of antisplash covers
   9.3. Removal and installation of a drive of forward wheels
   9.4. Removal and installation of the internal hinge
   9.5. Removal and installation of the external hinge
   9.6. Dismantling of the external hinge
   9.7. Dismantling of the internal hinge
   9.8. Quencher of krutilny fluctuations of a power shaft
   9.9. Epiploon of a flange of a semi-axis
   9.10. Malfunctions of power shafts
+ 10. Suspension brackets
+ 11. Steering
+ 12. Brake system
+ 13. Wheels and tires
+ 14. Systems of heating, ventilation and conditioning
+ 15. Electric equipment
+ 16. Body
+ 17. Electric circuits


Repair B3-B4/Passat B3-B4 Volkswagen Passat>> Drive of forward wheels>> Quencher of krutilny fluctuations of a power shaft
Removal and installation of a quencher of krutilny fluctuations carry out in the following order:
– will hang out a forward part of the car and fix it basic racks;
– clear a quencher of krutilny fluctuations then turn it so that to provide access to the cylindrical pin fastening together two half of a quencher;

Fig. 9.21. An arrangement of a cylindrical pin for connection of two half of a quencher of krutilny fluctuations


– a drift with a thin sting, beat out a cylindrical pin from a quencher and remove a quencher from a power shaft (fig. 9.21) .
Installation make in sequence, return to removal, thus use a new cylindrical pin. If it is necessary, replace a sticky tape under a quencher.

Monolithic quencher  since August, 1989
Removal and installation of a quencher of krutilny fluctuations carry out in the following order:
– remove the corresponding power shaft. Remove from a shaft the internal hinge.
– displace on a power shaft a quencher of krutilny fluctuations.

Fig. 9.22. An arrangement of a quencher of krutilny fluctuations (And) on driving to a shaft: and = 264,5 mm for the left shaft and 521 mm – for the right shaft


Installation make in sequence, return to removal. Establish a quencher on a shaft so that to sustain distance of installation of a quencher (fig. 9.22) . Establish the internal hinge and a power shaft.