VW Passat repair


+ 1. Ekspluatatsiiya of the car
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Power supply system
+ 6. Ignition system
+ 7. Coupling
+ 8. Transmission
+ 9. Drive of forward wheels
- 10. Suspension brackets
   + 10.1. Forward suspension bracket
   - 10.2. Back suspension bracket
      10.2.1. Technical characteristics
      10.2.2. General data
      10.2.3. Replacement of the bearing of a nave of a back wheel
      10.2.4. Pin of a back wheel
      10.2.5. Rack of a back suspension bracket
      10.2.6. Beam of a back suspension bracket
      10.2.7. Back suspension bracket of the all-wheel drive car (Syncro)
      10.2.9. System of self-alignment of a suspension bracket
+ 11. Steering
+ 12. Brake system
+ 13. Wheels and tires
+ 14. Systems of heating, ventilation and conditioning
+ 15. Electric equipment
+ 16. Body
+ 17. Electric circuits


Repair B3-B4/Passat B3-B4 Volkswagen Passat>> Suspension brackets>> Back suspension bracket>> Back suspension bracket of the all-wheel drive car (Syncro)

Fig. 10.35. Back suspension bracket of the all-wheel drive car (Syncro): 1–arm of a suspension bracket of a case of a reducer; 2–reducer; 3–drive shaft; 4–spring rack; 5–lever of a back suspension bracket; 6–support of fastening of a beam; 7–beam; 8–stabilizer of cross-section stability; 9–driveshaft


The back suspension bracket of the all-wheel drive car (Syncro) is shown on fig. 10.35 .

Corners of installation of back wheels  of the all-wheel drive car (Syncro)

Fig. 10.36. The Ekstsentrikovy plug for adjustment of a corner of installation of back wheels


Corners of installation of back wheels are regulated by means of saylent-blocks with ekstsentrikovy plugs (fig. 10.36) .
Disorder of back wheels.................. 1°25 '± 30'
Convergence of back wheels.......... 0°15 '± 20'

Adjustment of corners
Adjustment make in the following order:
– turn the ekstsentrikovy plug up at negative coal of disorder;
– turn the ekstsentrikovy plug down at positive coal of disorder;
– turn the ekstsentrikovy plug forward at a positive convergence;
– turn the ekstsentrikovy plug back at a negative convergence.

Replacement of a pillow of a suspension bracket of a case of a reducer of a back suspension bracket
Remove a support of a suspension bracket of a case of a reducer of the back bridge.
Vypressuyte a suspension bracket pillow from a support.

Replacement сайлентблоков support of fastening of a beam
Replacement make in the following order:
– remove a support of fastening of a beam from the car;
– establish a chisel between saylentbloky and a support;
– take by means of the lever in;;;;;;;;;;;;;
– tweezers take other loose leaf;

Fig. 10.37. Installation of loose leaves сайлентблока beams


– the new loose leaf сайлентблока establish at an angle 40 ° in relation to a longitudinal axis of the car by means of the adaptation 3084 (fig. 10.37) ;
– establish a support on the car and check corners of installation of wheels.