VW Passat repair


+ 1. Ekspluatatsiiya of the car
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Power supply system
+ 6. Ignition system
+ 7. Coupling
+ 8. Transmission
+ 9. Drive of forward wheels
- 10. Suspension brackets
   + 10.1. Forward suspension bracket
   - 10.2. Back suspension bracket
      10.2.1. Technical characteristics
      10.2.2. General data
      10.2.3. Replacement of the bearing of a nave of a back wheel
      10.2.4. Pin of a back wheel
      10.2.5. Rack of a back suspension bracket
      10.2.6. Beam of a back suspension bracket
      10.2.7. Back suspension bracket of the all-wheel drive car (Syncro)
      10.2.9. System of self-alignment of a suspension bracket
+ 11. Steering
+ 12. Brake system
+ 13. Wheels and tires
+ 14. Systems of heating, ventilation and conditioning
+ 15. Electric equipment
+ 16. Body
+ 17. Electric circuits


429b39f6





Repair B3-B4/Passat B3-B4 Volkswagen Passat>> Suspension brackets>> Back suspension bracket>> General data

Fig. 10.17. Back подвеска:1 – an amortization rack; 2–lever; 3–rezinometallichesky plugs; 4–lever of a regulator of pressure; 5–arm of fastening of a regulator of pressure; 6–back beam


Excepting the all-wheel drive version (Sincro), VW Passat cars have a back suspension bracket with partially connected levers and correcting rezinometallichesky plugs. The basis of a back suspension bracket is the V-shaped beam. Depending on capacity of the engine established on the car, in a back suspension bracket the stabilizer of cross-section stability can be established. But even without the stabilizer, the back beam carries out its functions, reducing car lists on turns. Levers 2 are welded on a beam from two parties (fig. 10.17) . The beam fastens to a body via rezinometallichesky plugs 3. The special form of plugs and their adjusting situation positively influence behavior of the car. When passing turns of the plug correct shift of a trace and obstruct to own traffic of a back axis. Amortization of a back suspension bracket is carried out by two amortizatorny racks 1.
All-wheel drive cars have a back suspension bracket with inclined levers.

       PREVENTION
Welding and leveling works on bearing elements of a back suspension bracket are inadmissible.