Removal of the stabilizer make in the following order:

– will hang out and fix on basic racks a forward part of the car;

– establish a jack under the central part of a cross-section beam and lift a jack so that the weight of a beam was perceived by a jack;

– unscrew fastening of a suspension bracket of the stabilizer of cross-section stability to a cross-section beam and a body. The forward bolt also fixes a back saylentblok of the cross-section lever;

– unscrew a nut of a connector of the stabilizer and disconnect the stabilizer of cross-section stability from the cross-section lever of a suspension bracket. Plates from sheet metal with a rubber support are established from two parties of the cross-section lever. At installation it is necessary to establish details on the places. The conic parties сайлентблоков are located from plates from sheet metal while the unbent edge of plates is directed in opposite from сайлентблоков the party;

– lower the stabilizer of cross-section stability and take it from under the car;

– check a condition of the stabilizer of cross-section stability and if necessary replace it;

– in case of wear or strong deformation replace plugs of fastening of the stabilizer to a body.

Installation of the stabilizer carry out to sequences, return to removal.

Nuts of fastening of the stabilizer tighten in situation «the car on wheels».