Removal and installation of a cable of an accelerator carry out in the following order:

– remove the bottom panel of furnish from the driver for access to fastening of a cable of an accelerator to a pedal;

– pushing via the rubber plug disconnect an accelerator cable from a pedal;

– open a cowl;

Fig. 5.17. Connection of a cable of an accelerator to a butterfly valve: 1–accelerator cable; 2–regulator of a cable and U-shaped bracket; 3–cable cover

– previously having removed a clamp, disconnect a cable 1 (fig. 5.17) of an accelerator from a butterfly valve;

– pull a cover of a cable 3 up and disconnect it from the holder. The U-shaped bracket 2 before the holder regulates the provision of a cable and if it is necessary to remove an U-shaped bracket, measure the adjusting provision of a cable which is required for adjustment at cable installation;

– note a cable arrangement, take it through a partition, and remove from the party of a motor compartment.

Installation is carried out to sequences, return to removal. Check, that the butterfly valve opened and closed completely and moved freely and smoothly.

If adjustment of a cable of an accelerator is necessary on cars with a mechanical transmission, see off her as follows:

Fig. 5.21. Adjustment of a cable of an accelerator on cars with a mechanical transmission: 1–the plug to move in the arrow direction; 2–fastening bracket

– 2 (see fig. 5.21 ) adjustments of a cable it is necessary to establish a bracket so that the butterfly valve was completely open at the pedal of an accelerator pressed against the stop;

Fig. 5.18. Adjustment of a cable of an accelerator on SOCH engines with a mechanical transmission

Fig. 5.19. Adjustment of a cable of an accelerator on DOCH engines with a mechanical transmission

– at completely released pedal of an accelerator the internal gap of a cable should not exceed 1,0 mm (fig. 5.18, 5.19) .

If adjustment of a cable of an accelerator is carried out on cars with an automatic transmission, see off her as follows:

Fig. 5.20. Adjustment of a cable of an accelerator on cars with a mechanical transmission: 1–whetstone; 2–pedal; 3–limiter; and = 15 mm

– insert whetstone 1 (fig. 5.20) in thickness of 15 mm between a pedal 2 accelerators and the limiter 3 and fix a pedal in this situation;

– on the end of a cable of an accelerator, at a butterfly valve, remove the plug of a cable completely to open a butterfly valve, then fix it in this situation, having inserted a fixing bracket;

– release a pedal of an accelerator and remove whetstone;

Fig. 5.22. Check of turning on of the mechanism of a low gear (kick-down)

– check operation of the mechanism of inclusion of a low gear (kick-down), having connected an ohmmeter to mechanism plugs (fig. 5.22) . At completely released pedal of an accelerator resistance should be equal to infinity;

– slowly press an accelerator pedal to a point of pressure of fall (only not to the limiter), thus resistance should be equal to zero.